M38 14 Ton 4X4 Utility Truck, Maintenance Manual (CA026544)

M38 14 Ton 4X4 Utility Truck, Maintenance Manual (CA026544)

• This manual presented for you in electronic format you can just print out the page you need then dispose of it when you have completed your task. This manual has detailed illustrations as well as step by step written instructions with the necessary diagrams or pictures. These manuals are your number one source for repair and service information, specifically written for the do-it-yourself as well as the experienced mechanics worldwide used to use this factory manual to fix your vehicle. Using this repair manual is an inexpensive way to keep your car working properly. it is this level of detail, along with illustrations, that guide the reader through each service, repairs, maintenance procedure.
• TM9 8912 1/4 Ton Utility Vehicle M38 Operation & Organizational Maintenance
  
  This is a quality reprint of US Army Manual TM9 8912, M38 maintenance manual. Originally published in January of 1956. It is a later document as the M38 had been in service by this time for five years and for practical purposes replaced by the M38A1. The M38 is my favorite jeep and always will be. If it is one of yours and you are lucky enough to posses one, here is an excellent resource for it.

  From the Manual:

  1. Scope

  a. These instructions are published for the use of personnel to whom this materiel is issued. They contain information on the operation and organizational maintenance of the materiel as well as descriptions of major units and their functions in relation to other components of the materiel.

  b. The appendix contains a list of current references, including supply manuals, forms, technical manuals, and other available publications applicable to the materiel.

  c. This manual differs from TM 9-804, September 1950, as indicated in (1 ), (2), and (3) below.

  (1) Adds information on

  (a) Plate showing “OFF” and “ON” positions under ignition switch, beginning with vehicle serial No. 26273.

  (b) A changed submersible starter mounting, beginning with vehicle serial No. 53262.

  (c) A submersible generator, beginning with vehicle serial No. 53262.

  (d) A sealed or pressurized bell housing, beginning with vehicle serial No. 53262.

  (e) A waterproof clutch linkage, beginning with vehicle serial No. 53262.

  (f) A 1/8-inch hole in crankshaft pulley for timing purposes, beginning with vehicle serial No. 22296.

  (g) Vent lines to bell housing, transfer case and transmission case, beginning with vehicle serial No. 53262.

  (h) Decalcomania above deep water fording vent valve control, for locating bell housing drain plug and fording information, beginning with vehicle serial No. 53262.

  (i)New engine rear plate for use with the changed starter mounting, beginning with vehicle serial No. 78513.

  (j) Decalcomania on fuel tank cap, beginning with vehicle serial No. 14693.

  (k) Distributor and voltage regulator harness assembly, beginning with vehicle serial No. 20600.

  (l)Indicates different length of speedometer cables used.

  (m) Cleaning of crankcase control valve and fuel filter element.

  (n) Installation of oil filter flexible inlet line and carburetor to fuel pump line.

  (o) Installation of thermostat housing retainer.

  (p) Installation of polarizing bracket for trailer coupling connector receptacle.

  (q) Replacement of old and new type stop light switches.

  (r) Installation of front axle brake line clamps.

  (2) Revises information on

  (a) Light switch, beginning with vehicle serial No. 66736.

  (b) Name, date, caution, and instruction plates.

  (c) Alemite fittings, beginning with vehicle serial No. 28300.

  (d) Instrument cluster, beginning with vehicle serial No. 65043.

  (e) Gear oil specification, in lubrication order temperature range + 40 ° F. to -10° F., using GO 75 in place of GO 90.

  (i) Forms, records, and reports.

  (g) Table I, special tools and equipment for organizational maintenance.

  (h) Circuit breaker, beginning with vehicle serial No. 65928.

  (3) Deletes reference to cartridge-type oil filter which was used only on pilot models. Cuno oil filter was used in all production vehicles.

  This is a Factory Service Manual in pdf format to study it on your PC or just print out the particular page or chapter you are working on, and not to worry about getting it dirty and oily.

  File Format: PDF
  
  Language: English
  
  Compatible: All Versions of Windows & Mac
  
  Requirements: Adobe PDF Reader /winzip

• You need the adobe Acrobat reader to view the document as the manual is pdf format. if your computer don’t have this application you can download and install it free from adobe acrobat website.
• With PDF file you can print unlimited copies. You can see on mobile phone, Ipad, Note, Computer
• You will be received download link after payment